Tough and reliable describes the AMIS power amplifiers. The AMIS120P is fan cooled can run via mains or 24VDC power supply, has rear panel volume and signal present LED and a variety of low impedance and constant voltage outputs.
Features
- Balanced XLR line level input with parallel output
- signal Present LED
- Rear panel level control
- Temperature Sensing Fan Cooling
- Current limiting protection
- 100V, 70V, 4 and 8 ohm outputs
- 2RU
- 240VAC/24VDC operation
Description
The AMIS120P is a 120 watt power amplifier with outputs for 4 and 8 ohms and 70 volt line. It may be desk or rack mounted. The AMIS120P features a flat screwdriver accessible gain control on the rear panel. This amplifier features a status LED.
Inputs and Outputs
The AMIS120P features a balanced line level XLR input with a parallel output to feed additional power amplifiers. The unit has industry standard 3 pin XLR microphone sockets. The AMIS120P features 70 volt, 8 and 4 ohm isolated transformer outputs via a rear panel barrier strip.
Protection
Internal current limiting protects the amplifier from both overload and overdrive conditions. Should the amplifier be overdriven, a current limiter will protect the unit, and in a worst case scenario the amplifier will shut down until the problem is resolved. Once the problem is fixed (shorted speaker line or overdriven input), the amplifier will automatically reset and continue operation. The AMIS120P features generous heatsinking. Australian Monitor Installation Series amplifiers feature a protection network that provides greater stability and performance. Our amplifiers are recognized worldwide for their reliability and this is due to the extensive levels of current limiting which protect the amplifiers from both overload and overdrive conditions.
SPECIFICATIONS
Power Output
120 Watts RMS
Maximum Load
40 Ohms @ 70 Volts
Power Bandwidth
60Hz - 17kHz (- 3dB)
Frequency Response
60Hz - 23kHz (- 3dB)
Total Harmonic Distortion
0.5% @ 1kHz rated power
Signal To Noise Ratio
-80dB
Input Sensitivity
700mV
Outputs
70V, 4 Ohm, 8 Ohm
Controls
One gain control on rear of the unit via flathead screwdriver control
Indicators
Power “on” LED
Power Source
120VAC 60Hz 3 pin IEC connector; 24VDC
Power Consumption
300 Watts
Protection
Current Limiter protection, plus AC and DC fuses
Dimensions
3.5" H x 19" W x 11" D
Weight
26.5lb
Rack Mounting
Standard
|
Products 